| dim. |
description |
distance |
description |
| a |
Distance from form bead center to outer hole of front reinforcement for suspension seat |
895 mm, 35 1/4" |
Fasten an approximately 125 mm, (5") long M10 bolt into the outside treaded hole of the suspension seat.
Bolt protrusion (to top of bolt head) should be 104 mm, (4 3/32"). the measure from center of form bead to center of bolt head. |
| b |
Distance between form bead center and seat of transverse front suspension tube |
473 mm,
18 5/8" |
Measured directly between hole center and form bead center |
| c |
Distance between form bead center and the rear outer hole of the suspension arm attatchment |
846 mm,
33 5/16" |
Fasten an approximately 230 mm (9") long M10 bolt into the suspension
seat. Bolt protrusion (to top of bolthead) should be 182 mm, (7 5/32"). then measure from center of form
bead to center of bolt head. |
| d |
Diagonal distance across rear floor between front and rear locating recesses |
17601 mm,
69 9/32" |
Measured between hole centers |
| e |
Distance between front locating recesses |
1184 mm,
46 5/8" |
Measured between hole centers |
| f |
Distance between rear locating recesses |
1272 mm,
50 3/32" |
Measured between hole centers |
| g |
Distance between the rear reinforcements for suspension seat |
590 mm,
23 7/32" |
Measured between hole centers |
| h |
Distance between attatching points of front transverse suspension tube |
726 mm,
28 19/32" |
Measured between hole centers |
